TL24 Radio Mute Circuit Short To Battery
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
Whenever the Toyota Link speaker is activated, the audio system (radio) mute signal is also activated and the mayday ECU grounds the audio system mute circuit causing the circuit voltage to be pulled low, less than 0.2 V.This low voltage is detected by the audio system as a radio mute request. When received, the radio will mute.
DTC TL24 is set when the output is shorted to battery voltage while being driven low by the mayday ECU.
INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TESTS |
Select: Systems Menu / Diagnosis / Active Tests.
Turn the audio ON.
Using the TDT, turn the audio mute ON.
Does the audio mute when the mute function is activated?
|
|
||||
| NO | |
| 2. CHECK THE MUTE SIGNAL VOLTAGE |
Disconnect the mayday ECU unit connector N46.

Turn the audio ON.
Connect a digital multimeter between terminal 7 and ground and check for voltage.
- OK:
- 5 V
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS |
Disconnect the navigation receiver connector F42.

Connect a digital multimeter between terminal 6 and mayday ECU unit connector N46 terminal 7 and check for continuity.
- OK:
- Less than 1 Ω
|
|
||||
| OK | ||
| ||
| 4. CHECK MAYDAY ECU |
Connect the navigation receiver connector F42.

Turn the audio ON.
Using a fused jumper wire, connect mayday ECU connector N46 terminal 7 to ground.
Does the audio mute operate when the jumper wire is connected to ground?
|
|
||||
| YES | |
| 5. CHECK MAYDAY ECU WIRE HARNESS |
Disconnect the mayday ECU connectors A and B.

Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 6. CHECK MAYDAY ECU CONNECTORS |
Are the mayday ECU connectors tight?
|
|
||||
| YES | ||
| ||
