2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL27 Key pad Not Detected

Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The mayday ECU key pad is a resistor-encoded switch, which means that each button has a separate and different value resistor connected to it.
The mayday ECU uses a voltage divider circuit to determine which button has been pressed.
The ECU supplies a 12 V signal voltage to the roof console box connector on terminal +B1. Whenever a button is pressed the corresponding switch is closed and is connected to ground through a resistor.
The mayday ECU monitors the voltage which will change when any of the buttons are pressed.
During the mayday ECU self test, the key pad circuit voltage is measured to detect voltage. This self-test is only performed once whenever the mayday ECU is powered up, at this time the power to the key pad is off.
DTC TL27 is set if the key pad circuit voltage is less than 1.6 V of the mayday ECU supply voltage.

INSPECTION PROCEDURE


1. CHECK ROOF CONSOLE BOX KEY PAD VOLTAGE

  1. B169483E01
    Disconnect the mayday ECU unit connector N46.

  1. Turn the engine switch on (IG).

  1. Connect a digital multimeter between terminal 20 and ground and check for voltage.

    OK:
    10 - 14 V



OK
Go to step 5
NG


2. CHECK MAYDAY ECU

  1. B169476E01
    Reconnect the mayday ECU unit connector N46.

  1. Using the TDT, navigate to the Systems Menu.

  1. Select: Diagnosis / Data List, then scroll to Key pad voltage.

  1. Connect a digital multimeter between terminal 13 and ground.

  1. Monitor the key pad voltage whilst operating the key pad.

  1. Does the voltage change when a button is pressed?



NO
Go to step 7
YES


3. CHECK ROOF CONSOLE BOX CONNECTOR RETENTION
  1. Is the roof console box connector tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES


4. REPLACE ROOF CONSOLE BOX ASSEMBLY
  1. Clear all DTCs (Click here), and then verify operation.


NEXT

END

5. CHECK ROOF CONSOLE BOX VOLTAGE

  1. B169476E01
    Disconnect the roof console box connector Q16.

  1. Turn the engine switch on (IG).

  1. Connect a digital multimeter between mayday ECU unit connector N46 terminal 13 and ground and check for voltage.

    OK:
    0.2 V or greater



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY
OK


6. REPAIR THE OPEN OR SHORT TO BATTERY
  1. Clear all DTCs (Click here) and then verify operation.


NEXT

END

7. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


8. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL26 Radio Mute Voltage Too High (from Oct 2006)TL27 Key pad Not Detected (from Jun 2009) →