TL34 GPS Antenna Circuit Voltage Too Low
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
The mayday ECU controls both the GPS and GSM antennas, which are located on the rear parcel tray.The GPS antenna receives signals from satellites orbiting the earth and transmits these to the mayday ECU to determine the vehicle's position.
Signals from at least three GPS satellites must be received to accurately determine the vehicle's two-dimensional (2D) position. Signals from at least four GPS satellites must be received to accurately determine the vehicle's three-dimensional (3D) position. If signals from only three satellites are received, the mayday ECU cannot determine the vehicle's altitude.
The GPS antenna must not be obscured by any objects such as underground car parks, tunnels, bridges, buildings, objects on the parcel tray or after market window tinting. Any of these may affect GPS reception.
The GPS antenna is connected to the mayday ECU by a push on type connector. To determine the vehicle's position this GPS information is transmitted via SMS to the Toyota Link Call Centre whenever a call is made from the vehicle by pushing the roof console box key pad. The Toyota Link Call Centre is also able to track the vehicle using this GPS information.
DTC TL34 is set if the mayday ECU detects that the antenna circuit is less than 1 V.
INSPECTION PROCEDURE
| 1. CHECK DTCs |
Turn the engine switch on (IG).
Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.
Select: Back / History DTC / Clear Current DTCs.
Turn the engine switch off for 1 minute, then on (IG) again.
Is DTC TL34 reset?
|
|
||||
| YES | |
| 2. CHECK GPS ANTENNA OPERATION |
Connect a known good GPS antenna to the mayday ECU.
Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.
Select: Back / History DTC / Clear Current DTCs.
Turn the engine switch off for 1 minute, then on (IG) again.
Is DTC TL34 reset?
|
|
||||
| YES | |
| 3. CHECK MAYDAY ECU GPS HARNESS |
Disconnect the GPS antenna connector C1 and mayday ECU GPS connector.
Check for continuity of the GPS harness.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 4. CHECK MAYDAY ECU WIRE HARNESS |
Disconnect the mayday ECU connectors A and B.

Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 5. CHECK MAYDAY ECU CONNECTORS |
Are the mayday ECU connectors tight?
|
|
||||
| YES | ||
| ||
