2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL46 Emergency Button Stuck

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The Toyota Link key pad is a resistor-encoded switch, which means that each button has a separate and different value resistor connected to it.
The mayday ECU uses a voltage divider circuit to determine which button has been pressed.
The ECU supplies a 12 V signal voltage to the roof console box connector on terminal 2. Whenever a button is pressed, the corresponding switch is closed and connected to ground through a resistor. The mayday ECU monitors the voltage on terminal 13 which will change when any of the buttons are pressed.
When the Emergency button is pressed, the voltage on terminal 13 of the mayday ECU unit connector N46 will be approximately 3.8 V. The ECU determines this voltage as an Emergency button press.
The mayday ECU will initiate a voice call to an operator at the Toyota Link Call Centre and then send an SMS message containing status and location data.
If the call cannot be connected, the mayday ECU will immediately re-attempt to connect the call a second time. If the second attempt also fails, the unit will wait for 60 seconds and make a third and final attempt.
If the Emergency button is pressed while a Toyota Link call is in progress, the status of the call will be upgraded to an Emergency call, and the mayday ECU will not be permitted to terminate the call by pressing the End Call button.
If the Emergency button is pressed while the vehicle is outside GSM network range, the mayday ECU will enter Emergency Call mode, whereby the emergency call request will be retained. When contact is re-established with the GSM network, the Emergency call will be placed immediately.
DTC TL46 is set if the Emergency button is pressed for longer than 10 seconds.

INSPECTION PROCEDURE


1. CHECK DTCs
  1. Turn the engine switch on (IG).

  1. Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.

  1. Select: Back / History DTC / Clear Current DTCs.

  1. Turn the engine switch off for 1 minute, then on (IG) again.

  1. Is DTC TL46 reset?



NO
THE PROBLEM IS INTERMITTENT, CHECK THE MAYDAY ECU, WIRE HARNESS AND CONNECTORS
YES


2. CHECK ROOF CONSOLE BOX BUTTON SIGNAL VOLTAGE

  1. B169481E02
    Connect a digital multimeter between roof console box connector Q16 terminal 9 and ground.

  1. Turn the engine switch on (IG).

  1. Press the End Call button and check for voltage.

    OK:
    3.8 V



NG
Go to step 4
OK


3. CHECK BUTTON SUPPLY VOLTAGE

  1. B169481E01
    Disconnect the roof console box connector Q16.

  1. Connect a digital multimeter between terminal 2 and ground.

  1. Turn the engine switch on (IG) and check for voltage.

    OK:
    12 - 14 V



NG
REPLACE THE ROOF CONSOLE BOX ASSEMBLY
OK


4. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


5. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL45 Toyota Link Button Stuck (from Oct 2006)TL5 Ignition Fault (Oct 2006 – May 2009) →