2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


DIAGNOSTIC TROUBLE CODES
When the mayday ECU detects an operating parameter that is outside its calibrated values, it will set a DTC and store this DTC into its memory as a current DTC.
When a current DTC is set the red status LED may be illuminated whenever the engine switch is on (IG).
The six most recent DTCs that have occurred will be logged in the mayday ECU's memory in a table known as the DTC List.
The DTC list can contain history data for the six most recent DTCs. Therefore, if more than six DTCs are set, only history data for the last six will be tracked. That is, the oldest DTC will be removed from the list regardless of its position within the list.
The DTC history data contained in the DTC List is as follows:
A particular DTC is only set once per ignition cycle. If the DTC does not exist in the DTC List, it is inserted into the list at the first vacant location, with the occurrence count set to 1 and the history count set to 0.
If the DTC List is full, the oldest DTC will be removed from the list; the history count determines the age of a DTC List entry.
The item in the list with the highest History Count will be removed to make space for the new DTC.
If the DTC already exists in the DTC List, then the occurrence count will be incremented, up to 255, at which point it is no longer incremented.
Each time the DTC is set, the history count is cleared. This ensures that the six most recent fault conditions are tracked.
The occurrence and history counters provide a means of determining how often the fault has occurred and how long it has been since the fault last occurred. For instance, if the DTC occurrence count is 1, and the history count is 201, then it can be determined that the fault condition existed only once, and it happened 201 ignition cycles ago, but has not been detected since.
Another example would be an occurrence count of 4 and a history count of 0; this would indicate that the fault has been detected a total of four times in the current ignition cycle.
The DTCs are not removed from the list, unless six newer fault conditions occur pushing the oldest fault off the list, or they are cleared using the Toyota Link Diagnostic Tool (TDT). For description and operation of the TDT (Click here).

NOTICE:
Once a DTC has been removed from the DTC List it is maintained in the memory of the mayday ECU as a history DTC, however there will be no DTC history data available for this DTC.

List Position
Position within the list numbered from 1 to 6.
DTC Number
The DTC number is the number used to identify a particular fault condition.
Occurrence Count
(0 to 255)
The Occurrence Count is the number of times the particular fault condition has been detected.
History Count
(0 to 255)
The History Count is the number of ignition cycles that have occurred since the fault was last detected. A count of 0 indicates the fault has occurred on the current ignition cycle, while a count of 255 indicates that the fault occurred 255 or more ignition cycles ago.

NOTICE:
Once a DTC has been removed from the DTC List it is maintained in the memory of the mayday ECU as a History DTC, however there will be no DTC history data available for this DTC.

← TERMINALS OF ECU (from Oct 2006)DIAGNOSIS SYSTEM (from Jun 2009) →