2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jun 2009


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Navigation System / DTC.

  5. Check the details of the DTCs (Click here).

    HINT:
    The navigation receiver assembly may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
    System
    Proceed to
    Navigation System
    Click here


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the intelligent tester on.

  4. Operate the intelligent tester to clear the codes. Enter the following menus: Body / Navigation System / DTC.

  5. According to the display on the intelligent tester, select the trouble code data display with the clear button.

← TERMINALS OF ECU (from Jun 2009)DIAGNOSTIC TROUBLE CODE CHART (from Jun 2009) →