2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clearance Sonar Main Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

When the clearance sonar main switch is turned on, an ON signal is sent to the clearance warning ECU and the indicator on the switch comes on. The Toyota parking assist-sensor system starts operating according to this signal.

WIRING DIAGRAM

B150844E05

INSPECTION PROCEDURE


1. INSPECT CLEARANCE SONAR MAIN SWITCH ASSEMBLY

  1. B139331E03
    Remove the clearance sonar main switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (ECU) - 6 (IG)
    Switch free (OFF)
    10 kΩ or higher
    Switch pushed (ON)
    Below 1 Ω



NG
REPLACE CLEARANCE SONAR MAIN SWITCH ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE SONAR MAIN SWITCH - BATTERY)

  1. B139332E01
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E73-6 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE SONAR MAIN SWITCH)

  1. B139333E02
    Disconnect the O30 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-12 (CLSW) - E73-3 (ECU)
    Always
    Below 1 Ω
    O30-12 (CLSW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Sonar Main Switch Circuit (Oct 2006 – May 2009)Clearance Warning Buzzer Circuit (Oct 2006 – May 2009) →