Home › TRANSMISSION · U660E AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C110340E41
  1. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
    Standard resistance: 
    Shift Position
    Tester Connection
    Specified Condition
    P
    1 (RB) - 3 (PL) and 4 (B) - 9 (L)
    Below 1 Ω
    Except P
    ↑
    10 kΩ or higher
    R
    2 (RL) - 1 (RB)
    Below 1 Ω
    Except R
    ↑
    10 kΩ or higher
    N
    1 (RB) - 8 (NL) and 4 (B) - 9 (L)
    Below 1 Ω
    Except N
    ↑
    10 kΩ or higher
    D, S, "+" and "-"
    1 (RB) - 7 (DL)
    Below 1 Ω
    Except D, S, "+" and "-"
    ↑
    10 kΩ or higher
    If operation cannot be done as specified, replace the park/neutral position switch.