TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY) |
![]() |
Disconnect the O28 connector from the clearance warning ECU.
Measure the voltage according to the value(s) on the table below.
| Tester Connection | Condition | Specified Condition |
| O28-15 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| O28-15 (IG) - Body ground | Ignition switch off | Below 1 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O28-17 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||