Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the clearance warning ECU.

WIRING DIAGRAM


E162483E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)


    E149933E53
  1. Disconnect the O28 connector from the clearance warning ECU.

  1. Measure the voltage according to the value(s) on the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    O28-15 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    O28-15 (IG) - Body ground
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND)


    E149933E54
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O28-17 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)