Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE ANTI-SQUEAL SPRING (w/ Anti-squeal Spring)
  1. Remove the 2 anti-squeal springs.



2. REMOVE FRONT BRAKE PAD
  1. Remove the 2 brake pads from the front disc brake cylinder mounting.



3. REMOVE FRONT ANTI-SQUEAL SHIM
  1. Remove the 2 front anti-squeal shims and the 2 pad wear indicators from each pad.



4. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 4 front disc brake pad support plates.



5. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING


    C132796
  1. Remove the 2 bolts and front disc brake cylinder mounting.



6. REMOVE NO. 1 FRONT DISC BRAKE CYLINDER SLIDE PIN


    C132798E03
  1. Remove the No. 1 front disc brake cylinder slide pin from the front disc brake cylinder mounting.



7. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN
  1. Remove the No. 2 front disc brake cylinder slide pin from the front disc brake cylinder mounting.



8. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING


    C132797
  1. Using a screwdriver, remove the front disc brake cylinder slide bushing from the No. 2 front disc brake cylinder slide pin.

    NOTICE:
    Do not damage the No. 2 front disc brake cylinder slide pin.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT


    C132799E03
  1. Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.



10. REMOVE CYLINDER BOOT


    C132808
  1. Using a screwdriver, remove the cylinder boot set ring and the cylinder boot.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.



11. REMOVE FRONT DISC BRAKE PISTON


    C111364E08
  1. Prepare a wooden plate to hold the front disc brake piston.

  1. Place the wooden plate between the front disc brake piston and the disc brake cylinder assembly.



    C132795
  1. Use compressed air to remove the front disc brake piston from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.



12. REMOVE PISTON SEAL


    C132807
  1. Using a screwdriver, remove the piston seal from the disc brake cylinder assembly.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.

    HINT:
    Tape the screwdriver tip before use.



13. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


14. REMOVE FRONT DISC BRAKE BLEEDER PLUG


15. REMOVE FRONT DISC


    C132801E01
  1. Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.