ROOF DRIP SIDE FINISH MOULDING > INSTALLATION |
| 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP |
![]() |
Apply a 2 to 3 mm (0.07 to 0.11 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.
Install the roof drip side finish moulding clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the roof drip side finish moulding clips after lightly rubbing up adhesive (3M DP-105 or equivalent).

| Area | Dimension |
| A | 1.4 mm (0.055 in.) |
| B | 12.4 mm (0.488 in.) |
| C | 1.1 mm (0.043 in.) |
| D | 12.1 mm (0.476 in.) |
| 2. INSTALL ROOF DRIP SIDE FINISH MOULDING CENTER |
Install the roof drip side finish moulding center when 20 minutes or more have elapsed after pressing and installing the roof drip side finish moulding clips.
