Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here



1. REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER

HINT:
When removing the roof drip side finish moulding center, heat the body and roof drip side finish moulding center using heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and moulding excessively.



    B135478E01
  1. Put protective tape around the roof drip side finish moulding center.



    B135479E01
  1. Using a moulding remover, disengage the 2 clips and remove the roof drip side finish moulding center.

    NOTICE:
    1. Do not remove the clips.
    2. If the clips are damaged or dropped off, replace them with new ones.



2. REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP

HINT:
Perform the following procedure if replacing the roof drip side finish moulding clips.



    B135480
  1. Remove the 2 roof drip side finish moulding clips.