TELEVISION CAMERA > REMOVAL |
| 1. REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP (w/ Assist Grip) |
![]() |
Using a screwdriver, disengage the 3 claws and open the assist grip cover.
![]() |
Remove the 2 screws and luggage compartment door assist grip.
| 2. REMOVE LUGGAGE COMPARTMENT DOOR COVER |
![]() |
Using a clip remover, remove the 13 clips and luggage compartment door cover.
| 3. REMOVE LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY |
![]() |
Disconnect the rod.
![]() |
Disconnect the cable and connector.
![]() |
Remove the 2 nuts and luggage compartment door lock cylinder assembly.
| 4. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH ASSEMBLY |
![]() |
Put protective tape around the luggage compartment door outside garnish assembly.
![]() |
Remove the 3 nuts.
![]() |
Using a moulding remover, disengage the 2 clips and remove the luggage compartment door outside garnish assembly.
| 5. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/o Entry and Start System) |
![]() |
Remove the 2 screws and rear television camera assembly.
| 6. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Entry and Start System) |
![]() |
Disengage the 3 clamps, 3 guides and wire harness.
![]() |
Disengage the clamp and wire harness.
Separate the cushion tape enough to allow the connector to be disconnected.
![]() |
Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool to the side of the claw engagement portion as shown in the illustration, tilt up the claw on the connector and disconnect the camera connector.
![]() |
Remove the 2 screws and rear television camera assembly.