Home › BODY › EXTERIOR › REAR DOOR BLACK OUT TAPE

REAR DOOR BLACK OUT TAPE > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    B136445E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.



2. REMOVE DOOR ASSIST GRIP COVER


    B149028E01
  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the door assist grip cover.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B136449
  1. Remove the 3 screws.

  1. Using a clip remover, disengage the 7 clips.



    B136450
  1. Raise the rear door trim board to disengage the 4 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

  1. Disconnect the connector.



    B136453
  1. Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.



    B141704
  1. Disengage the clip as shown in the illustration and remove the No. 1 door scuff plate clamp from the rear door trim board.



4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP


    B136456
  1. Disengage the 3 clips as shown in the illustration and remove the rear door inner glass weatherstrip from the rear door trim board.



5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY


    B136459
  1. Disconnect the cables and remove the rear door inside handle sub-assembly.



6. REMOVE REAR DOOR SERVICE HOLE COVER


    B136461
  1. Disconnect the connector.

  1. Remove the rear door service hole cover.

    HINT:
    Remove the remaining tape on the door side.



7. REMOVE REAR DOOR GLASS RUN


    B136466
  1. Remove the rear door glass run.



8. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY


    B136467
  1. Remove the 2 bolts, the screw, and the rear door lower window frame sub-assembly.



9. REMOVE REAR DOOR QUARTER WINDOW GLASS


    B136468
  1. Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.

  1. Remove the rear door quarter window glass from the rear door quarter window weatherstrip.



10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


    B136470
  1. Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

    NOTICE:
    Do not damage the door glass.



11. REMOVE REAR DOOR WEATHERSTRIP


    B129819
  1. Using a clip remover, disengage the clip and remove the rear door weatherstrip.



12. REMOVE REAR DOOR FRAME GARNISH


    B136882
  1. Disengage the clip and remove the rear door frame garnish.



13. REMOVE REAR DOOR OUTSIDE STRIPE
  1. Using a heat light, heat the rear door outside stripe.

    Heating temperature:
    Item
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)

    NOTICE:
    Do not heat the vehicle body excessively.

  1. Pull back an edge of the rear door outside stripe and pull it parallel to the vehicle body to pull it off.



14. REMOVE REAR DOOR LOWER OUTSIDE STRIPE
  1. Using a heat light, heat the rear door lower outside stripe.

    Heating temperature:
    Item
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)

    NOTICE:
    Do not heat the vehicle body excessively.

  1. Pull back an edge of the rear door lower outside stripe and pull it parallel to the vehicle body to pull it off.