Home › TRANSMISSION ยท U250E AUTOMATIC TRANSAXLE › SPEED SENSOR

SPEED SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE BATTERY


    A134906
  1. Loosen the bolt and nut, and remove the battery clamp.

  1. Remove the battery and battery tray.



3. REMOVE AIR CLEANER INLET ASSEMBLY


    A134903
  1. Remove the 2 bolts, clamp and air cleaner inlet.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A135666E01
  1. Disconnect the mass air flow meter connector (*1).

  1. Disconnect the purge VSV connector (*2).

  1. Disconnect the 2 purge VSV vacuum hoses (*3).

  1. Disconnect the purge line hose from the clamp (*4).



    A135667E01
  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.



    A135668
  1. Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.



    A135669
  1. Remove the 2 bolts and air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.



5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A134905
  1. Disconnect the hose clamp.

  1. Remove the 3 bolts and air cleaner case.



6. REMOVE SPEED SENSOR (NT SENSOR)


    C135106
  1. Disconnect the speed sensor connector.

  1. Remove the bolt and speed sensor.

  1. Remove the O-ring from the speed sensor.



7. REMOVE SPEED SENSOR (NC SENSOR)


    C135107
  1. Disconnect the speed sensor connector.

  1. Remove the bolt and speed sensor.

  1. Remove the O-ring from the speed sensor.