SFI SYSTEM > DIAGNOSIS SYSTEM |
| EURO-OBD |
![]() |
The emission control system components.
The power train control components (which affect vehicle emissions).
![]() |
The computer
In addition, if the applicable Diagnostic Trouble Codes (DTCs) prescribed by ISO 15765-4 are recorded in the ECM memory. If the malfunction does not reoccur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
To check DTCs, connect the intelligent tester or OBD scan tool to the Data Link Connector 3 (DLC3) of the vehicle.
The scan tool displays DTCs, the freeze frame data and a variety of engine data.
The DTCs and freeze frame data can be erased using the scan tool (Click here).
| M-OBD |
![]() |
The emission control system/components.
The power train control components (which affect vehicle emissions).
The computer
In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2-TRIP DETECTION LOGIC |
| DLC3 (Data Link Connector 3) |
![]() |
The ECM uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format. If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
| Symbol | Terminal No. | Name | Reference terminal | Result | Condition |
| SIL | 7 | Bus "+" line | 5 - Signal ground | Pulse generation | During transmission |
| CG | 4 | Chassis ground | Body ground | 1 Ω or less | Always |
| SG | 5 | Signal ground | Body ground | 1 Ω or less | |
| BAT | 16 | Battery positive | Body ground | 9 to 14 V | |
| CANH | 6 | CAN "High" Line | 14 - CANL | 54 to 69 Ω | Ignition switch off* |
| Battery positive | 6 kΩ or higher | ||||
| 4 - CG | 200 Ω or higher | ||||
| CANL | 14 | CAN "Low" Line | Battery positive | 6 kΩ or higher | |
| 4 - CG | 200 Ω or higher |
| INSPECT BATTERY VOLTAGE |
| CHECK MIL |
Check that the MIL illuminates when the ignition switch turns to the ON position.
If the MIL does not illuminate, there is a problem in the MIL circuit (Click here).
When the engine is started, the MIL should turn off.