SFI SYSTEM > DIAGNOSIS SYSTEM |
| EURO-OBD (EUROPE SPEC) |
![]() |
The emission control system/components
The power train control components (which affect vehicle emissions)
![]() |
The computer
In addition, the applicable Diagnostic Trouble Codes (DTCs) prescribed by ISO 15765-4 are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
To check for DTCs, connect the intelligent tester to the Data Link Connector 3 (DLC3) of the vehicle.
The scan tool displays DTCs, the freeze frame data and a variety of the engine data.
The DTCs and freeze frame data can be erased with the scan tool (Click here).
| M-OBD (EXCEPT EUROPEAN SPEC.) |
![]() |
The emission control system/components
The power train control components (which affect vehicle emissions)
The computer
In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2-TRIP DETECTION LOGIC |

| DLC3 (Data Link Connector 3) |
| Symbols (Terminal No.) | Terminal Description | Condition | Result |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Ignition switch OFF | 54 to 69 Ω |
| CANH (6) - CG (4) | High-level CAN bus line | Ignition switch OFF | 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch OFF | 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Ignition switch OFF | 200 Ω or higher |
| INSPECT BATTERY VOLTAGE |
| CHECK MIL |
Check that the MIL illuminates when turning the ignition switch to the ON position.
If the MIL does not illuminate, there is a problem in the MIL circuit (Click here).
When the engine is started, the MIL should turn off.
| ALL READINESS |