SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE (Using an intelligent tester) |
![]() |
Check and ensure the following condition:
Battery positive voltage 11 V or more.
Throttle valve fully closed.
Transmission in the P or N positions.
A/C switch OFF.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Power train / Engine / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure that the MIL flashes as shown in the illustration.
Start the engine.
Make sure that the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check for DTCs and freeze frame data using the tester.