DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic): (a) Throttle actuator duty ratio 80% or more (b) Throttle actuator current less than 0.5 A |
|
| P2103 | Either of the following conditions is met (1 trip detection logic):
|
|

| 1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle with motor body assembly .
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE WITH MOTOR BODY ASSEMBLY - ECM) |
Disconnect the throttle with motor body assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C5-2 (M+) - C24-42 (M+) | Always | Below 1 Ω |
| C5-1 (M-) - C24-41 (M-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C5-2 (M+) or C24-42 (M+) - Body ground | Always | 10 kΩ or higher |
| C5-1 (M-) or C24-41 (M-) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the throttle with motor body assembly connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||