DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | Open in ETCS power source (+BM) circuit (1 trip detection logic) |
|

| 1.READ VALUE USING INTELLIGENT TESTER (+BM VOLTAGE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Data List / +BM voltage.
Read the value displayed on the tester.
|
| ||||
| NG | |
| 2.CHECK FUSE (ETCS FUSE) |
![]() |
Remove the ETCS fuse from the engine room R/B.
Measure the resistance of the ETCS fuse.
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Remove the ETCS fuse from the engine room R/B.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the cable from the positive (+) battery terminal.
Disconnect the A24 ECM connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| ETCS fuse (2) - +BM (A24-3) | Below 1 Ω |
| Positive battery cable - ETCS fuse (1) | Below 1 Ω |
| Tester Connection | Specified Condition |
| ETCS fuse (2) or +BM (A24-3) - Body ground | 10 kΩ or higher |
| Positive battery cable or ETCS fuse (1) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the cable to the positive (+) battery terminal.
Reconnect the cable from the negative (-) battery terminal.
Reconnect the ECM connector.
|
| ||||
| OK | |
| Go to step 5 |
| 4.INSPECT ECM (+BM VOLTAGE) |
![]() |
Disconnect the A24 and C24 ECM connectors.
Measure the voltage between the terminals of the A24 and C24 ECM connectors.
| Tester Connection | Specified Condition |
| +BM (A24-3) - E1 (C24-104) | 9 to 14 V |
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||
| 5.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 6.CHECK BATTERY TERMINAL |
Check that the battery terminals and ECM ground are not loose or corroded.
|
| ||||
| OK | ||
| ||