DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | Open in ETCS power source (+BM) circuit (1 trip detection logic) |
|

| 1.CHECK FUSE (ETCS FUSE) |
![]() |
Remove the ETCS fuse from the engine room R/B.
Measure the resistance of the ETCS fuse.
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 2.INSPECT ECM (+BM VOLTAGE) |
![]() |
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| +BM (A24-3) - Body ground | 9 to 14 V |
| Tester Connection | Specified Condition |
| +BM (A55-3) - Body ground | 9 to 14 V |
Reconnect the ECM connector.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room R/B.
Disconnect the A24 (RHD) or A55 (LHD) ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| Engine room R/B ETCS fuse terminal 2 - +BM (A24-3) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Engine room R/B ETCS fuse terminal 2 - +BM (A55-3) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Engine room R/B ETCS fuse terminal 2 or +BM (A24-3) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| Engine room R/B ETCS fuse terminal 2 or +BM (A55-3) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the ECM connector.
Check the harness and connector between the ETCS fuse and positive battery cable.
Remove the ETCS fuse from the engine room R/B.
Disconnect the negative battery terminal.
Disconnect the positive battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| Positive battery terminal - Engine room R/B ETCS fuse terminal 1 | Below 1 Ω |
| Tester Connection | Specified Condition |
| Positive battery terminal or Engine room R/B ETCS fuse terminal 1 - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the positive battery terminal.
Reconnect the negative battery terminal.
|
| ||||
| OK | ||
| ||