Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION OF WASHER NOZZLE ADJUSTMENT
  1. Do not clean or adjust the washer nozzle with a safety pin, etc. because;

    1. the washer nozzle tip is made of resin and could be damaged.

    2. adjustment is not necessary because the washer nozzle is a spray type. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

  2. In case the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush, etc.