Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Front Wiper Motor Circuit

for Preparation Click here


DESCRIPTION

The auto wiper relay controls the front wiper motor.

WIRING DIAGRAM


E119083E02


INSPECTION PROCEDURE

1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY


    E034081E35
  1. Remove the windshield wiper motor assembly .

  1. Check the LO operation (for LHD).

    1. Connect the positive (+) battery lead to terminal B1-5 (+1) of the connector, and the negative (-) battery lead to terminal B1-4 (E), and check that the motor operates at low speed.

  1. Check the HI operation (for LHD).

    1. Connect the positive (+) battery lead to terminal B1-3 (+2) of the connector, and the negative (-) battery lead to terminal B1-1 (S), and check that the motor operates at high speed.



    E034081E36
  1. Check the LO operation (for RHD).

    1. Connect the positive (+) battery lead to terminal B1-1 (+1) of the connector, and the negative (-) battery lead to terminal B1-5 (E), and check that the motor operates at low speed.

  1. Check the HI operation (for RHD).

    1. Connect the positive (+) battery lead to terminal B1-4 (+2) of the connector, and the negative (-) battery lead to terminal B1-3 (S), and check that the motor operates at high speed.



NG
REPLACE WINDSHIELD WIPER MOTOR ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (WIPER MOTOR - WIPER RELAY, BODY GROUND)


    E124959E02
  1. Disconnect the B1 windshield wiper motor assembly connector.

  1. Disconnect the E26 windshield wiper relay assembly (auto wiper relay) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for LHD:
    Tester Connection
    Condition
    Specified Condition
    B1-1 (S) - E26-10 (+SM)
    Always
    Below 1 Ω
    B1-1 (S) - Body ground
    Always
    10 kΩ or higher
    B1-3 (+2) - E26-3 (+2)
    Always
    Below 1 Ω
    B1-3 (+2) - Body ground
    Always
    10 kΩ or higher
    B1-4 (E) - Body ground
    Always
    Below 1 Ω
    B1-5 (+1) - E26-2 (+1)
    Always
    Below 1 Ω
    B1-5 (+1) - Body ground
    Always
    10 kΩ or higher
    for RHD:
    Tester Connection
    Condition
    Specified Condition
    B1-1 (+1) - E26-2 (+1)
    Always
    Below 1 Ω
    B1-1 (+1) - Body ground
    Always
    10 kΩ or higher
    B1-3 (S) - E26-10 (+SM)
    Always
    Below 1 Ω
    B1-3 (S) - Body ground
    Always
    10 kΩ or higher
    B1-4 (+2) - E26-3 (+2)
    Always
    Below 1 Ω
    B1-4 (+2) - Body ground
    Always
    10 kΩ or higher
    B1-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE