CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit |
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Check the CRUISE main indicator light by performing the ACTIVE TEST.
| Item | Test Details | Diagnostic Note |
| Indicat. Lamp Cruise | Turns CRUISE main indicator light ON / OFF | - |
|
| ||||
| OK | |
| 2.READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester main switch on.
Check the DATA LIST for proper functioning of the CRUISE main indicator light.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| CCS Indicator M-CPU | Cruise indicator signal (Main CPU) / ON or OFF | ON: Cruise main indicator light on OFF: Cruise main indicator light off | - |
| Result | Proceed to |
| OK | A |
| NG (for 2AZ-FE) | B |
| NG (for 2GR-FE) | C |
|
| ||||
|
| ||||
| A | ||
| ||