CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Read the DATA LIST according to the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed | - |
| Memory Spd | Cruise control memorized speed / min.: 36 km/h (22.5 mph), max.: 200 km/h (125 mph) | Actual stored vehicle speed | - |
| Throttle | Throttle opening angle / min.: 0°, max.: 125° | Actual demanded throttle angle | - |
| Shift D Pos | Shift D position / ON or OFF | ON: Shift lever in D or 4 OFF: Shift lever is except D or 4 position | - |
| Cruise Control | Cruise control system active condition / ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated | - |
| CCS Indicator M | Cruise indicator signal (Main CPU) / ON or OFF | ON: "CRUISE" on OFF: "CRUISE" off | - |
| Main SW (Main) | Main switch signal (Main CPU) / ON or OFF | ON: Cruise control main switch on OFF: Cruise control main switch off | "1" |
| Main SW (Sub) | Main switch signal (Main CPU) / ON or OFF | ON: Cruise control main switch on OFF: Cruise control main switch off | - |
| Shift D Pos | Clutch pedal / ON or OFF | ON: Clutch pedal released OFF: Clutch pedal depressed | - |
| Cancel SW | CANCEL switch signal / ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off | - |
| SET/COAST SW | SET / COAST switch signal / ON or OFF | ON: - (COAST) / SET switch on OFF: - (COAST) / SET switch off | - |
| RES/ACC SW | RES / ACC switch signal / ON or OFF | ON: + (ACCEL) / RES (RESUME) switch on OFF: + (ACCEL) / RES (RESUME) switch off | - |
| Stp Light SW M (STP) | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Stp Light SW S2 (STP) | Stop light switch signal (Sub CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Stp Light SW S1 (ST1-) | Stop light switch signal (Sub CPU) | ON: Brake pedal depressed OFF: Brake pedal released | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Perform the ACTIVE TEST according to the display on the tester.
| Tester Display | Test Part | Control Range |
| CRUISE INDIC | Turns CRUISE main indicator light ON / OFF | - |