CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Read the DATA LIST according to the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed | - |
| CCS Mem Vehicle Spd | Cruise control memorized speed / min.: 36 km/h (22.5 mph), max.: 200 km/h (125 mph) | Actual stored vehicle speed | - |
| Throttle Opening Angle | Throttle opening angle / min.: 0°, max.: 125° | Actual demanded throttle angle | - |
| Cruise Control | Cruise control system active condition / ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated | - |
| CCS Indicator M-CPU | Cruise indicator signal (Main CPU) / ON or OFF | ON: Cruise main indicator light on OFF: Cruise main indicator light off | - |
| Main SW M-CPU | Main switch signal (Main CPU) / ON or OFF | ON: Cruise control main switch on OFF: Cruise control main switch off | - |
| Main SW S-CPU | Main switch signal (Main CPU) / ON or OFF | ON: Cruise control main switch on OFF: Cruise control main switch off | - |
| Cancel Switch | CANCEL switch signal / ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off | - |
| SET/COAST Switch | SET / COAST switch signal / ON or OFF | ON: - (COAST) / SET switch on OFF: - (COAST) / SET switch off | - |
| RES/ACC Switch | RES / ACC switch signal / ON or OFF | ON: + (ACCEL) / RES (RESUME) switch on OFF: + (ACCEL) / RES (RESUME) switch off | - |
| Stp Light SW M-CPU | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Stp Light SW S2-CPU | Stop light switch signal (Sub CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Stp Light SW S1-CPU | Stop light switch signal (Sub CPU) | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Cruise Operation Status | Shift D position / ON or OFF | ON: Shift lever in D OFF: Shift lever not in D | - |
| Clutch switch signal / ON or OFF | ON: Clutch pedal released OFF: Clutch pedal depressed | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Perform the ACTIVE TEST according to the display on the tester.
| Tester Display | Test Part | Control Range |
| Indicat. Lamp Cruise | Turns CRUISE main indicator light ON / OFF | - |