Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Vehicle Position Mark Deviates Greatly

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK GPS MARK


    E181031
  1. Check that the GPS mark is displayed.

    OK:
    GPS mark is displayed.



NG
GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


2.CHECK VEHICLE SENSOR (OPERATION CHECK)


    E176549
  1. Display the "Vehicle Sensors" screen (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are almost equal.

    OK:
    The readings are almost equal.



NG
CHECK DTC OUTPUT (Click here)
OK


3.CHECK VEHICLE SIGNAL (OPERATION CHECK)
  1. Display the "Vehicle Signal Check Mode" screen (Click here).



    E176550
  1. Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Shift Lever Position
    Display
    Except R
    OFF
    R
    ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
CHECK DTC OUTPUT (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)