Home › ENGINE ยท 2GR-FE › EMISSION CONTROL › VENTILATION VALVE

VENTILATION VALVE > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A132968
  1. Hold the front of the V-bank cover and raise it to disengage the 2 retainers on the front of the cover. Continue to raise the cover to disengage the retainer on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. DISCONNECT VENTILATION HOSE


    A135715E01
  1. Disconnect the ventilation hose from the ventilation valve.



3. REMOVE VENTILATION VALVE


    A138519E01
  1. Remove the ventilation valve.