BRAKE PEDAL > ADJUSTMENT |
| 1. CHECK AND ADJUST BRAKE PEDAL HEIGHT |
![]() |
Check the brake pedal height.
| Model | Transaxle | Specified condition |
| LHD | Automatic | 129.9 to 139.9 mm (5.114 to 5.508 in.) |
| Manual | 131.9 to 141.9 mm (5.193 to 5.587 in.) | |
| RHD | Automatic | 135.5 to 145.5 mm (5.335 to 5.728 in.) |
| Manual | 137.5 to 147.5 mm (5.413 to 5.807 in.) |
Adjust the brake pedal height.
Disconnect the connector from the stop light switch assembly.
Remove the stop light switch.
Loosen the push rod clevis lock nut.
Adjust the pedal height by turning the push rod.
Tighten the clevis lock nut.
![]() |
Insert the switch into the adjuster until the switch body touches the pedal.
Rotate the switch a quarter turn clockwise.
Connect the connector.
![]() |
Check the switch clearance.
| 2. CHECK PEDAL FREE PLAY |
![]() |
Stop the engine. Press the pedal several times until no vacuum is left in the booster. Release the pedal.
Depress the pedal until a slight resistance is felt. Measure the distance as shown in the illustration.
Check the switch clearance.
| 3. CHECK PEDAL RESERVE DISTANCE |
![]() |
Release the parking brake pedal or parking brake lever.
With the engine running, depress the brake pedal and measure the pedal reserve distance as shown in the illustration.
| Model | Transaxle | Specified condition |
| LHD | Automatic | 61 mm (2.402 in.) |
| Manual | 63 mm (2.480 in.) | |
| RHD | Automatic | 65 mm (2.559 in.) |
| Manual | 67 mm (2.638 in.) |