Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

This DTC is stored when there is an open or short in the transponder key coil (built into the engine switch).

DTC Code
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open or shorted.
  1. Wire harness or connector
  2. Certification ECU (Smart key ECU assembly)
  3. Engine switch

WIRING DIAGRAM


B219132E07


INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register all the keys.

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    B2784 output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)
  1. Disconnect the certification ECU (smart key ECU assembly) connector.



    B219228E01
  1. Disconnect the engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-8 (TXCT) - E70-9 (TXCT)
    Always
    Below 1 Ω
    E74-9 (CODE) - E70-10 (CODE)
    Always
    Below 1 Ω
    E74-8 (TXCT) - Body ground
    Always
    10 kΩ or higher
    E74-9 (CODE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE ENGINE SWITCH
  1. Replace the engine switch (Click here).


NEXT


4.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    B2784 output does not recur.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (ENGINE SWITCH WAS DEFECTIVE)