DTC B2799 Engine Immobiliser System Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2799 | One of the following conditions is met:
|
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.RE-REGISTER ECU COMMUNICATION ID |
Re-register the ECU communication ID.
| NEXT | |
| 3.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK CONNECTOR CONNECTION CONDITION |
Turn the engine switch off.
Check that the connectors are properly connected to the ECM and ID code box (immobiliser code ECU).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (ID CODE BOX - ECM) |
Disconnect the ID code box (immobiliser code ECU) connector.
Disconnect the ECM connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E68-5 (EFII) - A24-10 (IMO) | Always | Below 1 Ω |
| E68-6 (EFIO) - A24-11 (IMI) | Always | Below 1 Ω |
| E68-5 (EFII) - Body ground | Always | 10 kΩ or higher |
| E68-6 (EFIO) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| E68-5 (EFII) - A55-10 (IMO) | Always | Below 1 Ω |
| E68-6 (EFIO) - A55-11 (IMI) | Always | Below 1 Ω |
| E68-5 (EFII) - Body ground | Always | 10 kΩ or higher |
| E68-6 (EFIO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 7.REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID.
| NEXT | |
| 8.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||