STEERING ANGLE SENSOR (w/ VSC) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 4. REMOVE NO. 2 LOWER STEERING WHEEL COVER |
![]() |
Using a screwdriver, disengage the claw and remove the No. 2 lower steering wheel cover.
| 5. REMOVE NO. 3 LOWER STEERING WHEEL COVER |
![]() |
Using a screwdriver, disengage the claw and remove the No. 3 lower steering wheel cover.
| 6. REMOVE STEERING PAD |
![]() |
Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
Disconnect the horn connector from the steering pad.
Disconnect the 2 airbag connectors and remove the steering pad.
Remove the steering pad.
| 7. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the steering main shaft.
Disconnect the connectors from the spiral cable.
![]() |
Using SST, remove the steering wheel assembly.
| 8. REMOVE STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
Disengage the 2 claws to remove the lower steering column cover.
![]() |
Disengage the claw to remove the upper steering column cover.
| 9. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR |
![]() |
Disconnect the connectors from the spiral cable with steering angle sensor.
Disengage the 3 claws and remove the spiral cable with steering angle sensor.
| 10. REMOVE STEERING ANGLE SENSOR |
![]() |
Disengage the 6 claws and remove the steering angle sensor from the spiral cable.