Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1441/41    Air Mix Damper Control Servo Motor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

The air mix damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper (passenger seat) to any position, which adjusts the amount of air passing the heater core after passing the evaporator to control the blowing temperature.

HINT:
Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or damper is mechanically locked.


DTC No.
DTC Detection Condition
Trouble Area
B1441/41
Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix control servo motor
  1. Air mix control servo motor
  2. Air conditioning harness
  3. A/C amplifier

WIRING DIAGRAM


E116879E09


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Operate the front passenger side temperature adjustment switch.

  1. Select the item below in the Data List, and read the display on the intelligent tester.


Data List / Air Conditioner: 
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Air Mix Servo Targ Pulse(P)
(Air Mix Pulse-P)
Passenger side air mix servo motor target pulse / Min.: 0, Max.: 255
LHD:
MAX. COLD: 105 (pulse)
MAX. HOT: 7 (pulse)
RHD:
MAX. COLD: 5 (pulse)
MAX. HOT: 103 (pulse)
-

OK:
The display is as specified in the normal condition column.


Result:

Result
Proceed to
NG
A
OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE)
B
OK (When troubleshooting according to the DTC)
C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2.REPLACE AIR MIX CONTROL SERVO MOTOR
  1. Replace the air mix control servo motor.

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC B1441/41 is output
    A
    DTC B1441/41 is not output
    B



B
END
A

REPLACE AIR CONDITIONING HARNESS