DTC B1442/42 Air Inlet Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1442/42 | Air inlet damper position sensor value does not change even if air conditioning amplifier operates air inlet control servo motor |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Operate the R/F (Recirculation/Fresh) switch.
Select the item below in the Data List, and read the display on the intelligent tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Air Inlet Damper Targ Pulse (A/I Damp Targ Pls) | Air inlet damper target pulse / Min.: 0, Max.: 255 | RECIRCULATION: 7 (pulse) FRESH: 28 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE) | B |
| OK (When troubleshooting according to the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE AIR INLET CONTROL SERVO MOTOR |
Replace the air inlet control servo motor.
Check for DTCs.
| Result | Proceed to |
| DTC B1442/42 is output | A |
| DTC B1442/42 is not output | B |
|
| ||||
| A | ||
| ||