Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1443/43    Air Outlet Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

The mode damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air outlet damper to any position, which controls the air outlet switching.

HINT:
Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or damper is mechanically locked.


DTC No.
DTC Detection Condition
Trouble Area
B1443/43
Air outlet damper position sensor value does not change even if air conditioning amplifier operates air outlet control servo motor
  1. Air outlet control servo motor
  2. Air conditioning harness
  3. A/C amplifier

WIRING DIAGRAM


E116879E11


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Operate the MODE switch.

  1. Select the item below in the Data List, and read the display on the intelligent tester.


Data List / Air Conditioner: 
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Air Outlet Servo Pulse (D)
(Air Out Pulse-D)
Driver side air outlet servo motor target pulse / Min.: 0, Max.: 255
FACE: 8 (pulse)
B/L: 30 to 38 (pulse)
FOOT: 50 to 74 (pulse)
FOOT/DEF: 80 (pulse)
DEF: 97 (pulse)
-

OK:
The display is as specified in the normal condition column.


Result:

Result
Proceed to
NG
A
OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE)
B
OK (When troubleshooting according to the DTC)
C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2.REPLACE AIR OUTLET CONTROL SERVO MOTOR
  1. Replace the air outlet control servo motor.

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC B1443/43 is output
    A
    DTC B1443/43 is not output
    B



B
END
A

REPLACE AIR CONDITIONING HARNESS