DTC P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) |
DTC P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0327 | Output voltage of knock control sensor is 0.5 V or less (1 trip detection logic) |
|
| P0328 | Output voltage of knock control sensor is 4.5 V or more (1 trip detection logic) |
|

| Item | Content |
| ECM Terminal Name | Between KNK1 and EKNK |
| Tester Range | 1 V/DIV., 1 ms./DIV. |
| Condition | Engine speed maintained at 4000 rpm after warming up engine |

| 1.INSPECT ECM (KNK1 VOLTAGE) |
![]() |
Disconnect the knock control sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| C30-1 - C30-2 | Ignition switch ON | 4.5 to 5.5 V |
| *1 | Front view of wire harness connector (to Knock Control Sensor) |
Reconnect the knock control sensor connector.
|
| ||||
| OK | |
| 2.INSPECT KNOCK CONTROL SENSOR |
![]() |
Remove the knock control sensor.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 120 to 280 kΩ |
| *1 | Component without harness connected (Knock Control Sensor) |
| *2 | Ohmmeter |
Reinstall the knock control sensor.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (KNOCK CONTROL SENSOR - ECM) |
Disconnect the knock control sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C30-2 - C24-110 (KNK1) | Always | Below 1 Ω |
| C30-1 - C24-111 (EKNK) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C30-2 or C24-110 (KNK1) - Body ground | Always | 10 kΩ or higher |
| C30-1 or C24-111 (EKNK) - Body ground | Always | 10 kΩ or higher |
Reconnect the knock control sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||