Home › TRANSMISSION · U660E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    P0560    System Voltage

for Preparation Click here


DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and set the DTC.

DTC No.
DTC Detection Condition
Trouble Area
P0560
Open in TCM back-up power source circuit.
DTC is detected for 3 sec. or more (1 trip detection logic).
  1. Open in back-up power source circuit
  2. TCM

HINT:
If DTC P0560 is set, the TCM does not store other DTCs.


WIRING DIAGRAM


A122745E03


INSPECTION PROCEDURE

1.INSPECT TERMINAL VOLTAGE (BATT VOLTAGE OF TCM)


    C133210E17
  1. Disconnect the TCM connector.

  1. Turn the ignition switch on.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    BATT (C56-1) - E1 (C56-8)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (EFI NO. 1 FUSE - TCM)
OK


2.CHECK HARNESS AND CONNECTOR


    C133210E20
  1. Disconnect the TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E1 (C56-8) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BODY GROUND)
OK

REPLACE TCM