DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in ECM back-up power source circuit (1 trip detection logic) |
|

| 1.CHECK FUSE (EFI NO. 1 FUSE) |
![]() |
Remove the EFI No. 1 fuse from the engine room J/B.
Measure the resistance of the EFI No. 1 fuse.
Reinstall the EFI No. 1 fuse.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE, EFI NO. 1 FUSE - BATTERY) |
![]() |
Check the harness and the connector between the EFI No. 1 fuse and ECM.
Remove the EFI No. 1 fuse from the engine room J/B.
Disconnect the A24 ECM connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| EFI No. 1 fuse (2) - BATT (A24-20) | Below 1 Ω |
| Tester Connection | Specified Condition |
| EFI No. 1 fuse (2) or BATT (A24-20) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the EFI No. 1 fuse.
Check the harness and the connector between the EFI No. 1 fuse and battery.
Remove the EFI No. 1 fuse from the engine room J/B.
Disconnect the negative battery terminal.
Disconnect the positive battery terminal.
Measure the resistance.
| Tester Connection | Specified Condition |
| Battery positive terminal - EFI No. 1 fuse (1) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Battery positive terminal or EFI No. 1 fuse (1) - Body ground | 10 kΩ or higher |
Reconnect the positive battery terminal.
Reconnect the negative battery terminal.
Reinstall the EFI No. 1 fuse.
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 5.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off and turn the tester off.
Start the engine and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT/ DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0560 | A |
| No output | B |
|
| ||||
| A | ||
| ||