DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in ECM back-up power source circuit (1 trip detection logic) |
|

| 1.INSPECT FUSE (EFI NO. 1) |
![]() |
Remove the EFI No. 1 fuse from the engine room R/B.
Measure the EFI No. 1 fuse resistance.
Reinstall the EFI No. 1 fuse.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR |
![]() |
Check the harness and connector between the EFI No. 1 fuse and ECM.
Remove the EFI No. 1 fuse from the engine room R/B.
Disconnect the A24 (RHD) or A55 (LHD) ECM connector.
Measure the resistance between the terminals.
| Tester Connection | Specified Condition |
| Engine room R/B EFI No. 1 fuse terminal 2 - BATT (A24-20) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Engine room R/B EFI No. 1 fuse terminal 2 - BATT (A55-20) | Below 1 Ω |
| Tester Connection | Specified Condition |
| Engine room R/B EFI No. 1 fuse terminal 2 or BATT (A24-20) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| Engine room R/B EFI No. 1 fuse terminal 2 or BATT (A55-20) - Body ground | 10 kΩ or higher |
Reinstall the ECM connector.
Check the harness and the connector between the EFI No. 1 fuse and battery.
Disconnect the negative battery terminal.
Disconnect the positive battery terminal.
Measure the resistance between the terminals.
| Tester Connection | Specified Condition |
| Battery positive terminal - Engine room R/B EFI No. 1 fuse terminal 1 | Below 1 Ω |
| Tester Connection | Specified Condition |
| Battery positive terminal or Engine room R/B EFI No. 1 fuse terminal 1 - Body ground | 10 kΩ or higher |
Reconnect the positive battery terminal.
Disconnect the negative battery terminal.
Reinstall the EFI No. 1 fuse.
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 4.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 5.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester on.
Clear the DTCs (Click here).
Turn the intelligent tester off.
Start the engine and turn the intelligent tester on.
Select the following menu items: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0560 | A |
| No output | B |
|
| ||||
| A | ||
| ||