DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in ECM back up power source circuit (1 trip detection logic) |
|

| 1.CHECK HARNESS AND CONNECTOR (EFI NO. 1 FUSE - ECM) |
Disconnect the ECM connector.
Remove the EFI No. 1 fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 (EFI No. 1 fuse) - A24-20 (BATT) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| 2 (EFI No. 1 fuse) or A24-20 (BATT) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the EFI fuse.
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 3.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | ||
| ||