DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | When either condition below is met:
|
|
| P0339 | Under conditions (a), (b) and (c), no CKP sensor signal to ECM for 0.05 seconds or more (1 trip detection logic): (a) Engine speed 1,000 rpm or more (b) Starter signal OFF (c) 3 seconds or more have lapsed since starter signal switched from ON to OFF |
|
![]() |
| Item | Content |
| Terminals | CH1: G2+ - G2- CH2: NE+ - NE- |
| Equipment Settings | 5 V/DIV. 20 ms./DIV. |
| Conditions | Cranking or idling |

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Data List / Engine Speed.
Start the engine.
Read the values displayed on the tester while the engine is running.
|
| ||||
| OK | ||
| ||
| 2.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C20 Crankshaft Position (CKP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connection | Specified Condition |
| 1 - 2 | 1,150 to 1,450 Ω (at 20°C (68°F)) |
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C20 CKP sensor connector.
Disconnect the C24 ECM connector.
Measure the resistance between the terminals of the wire harness side connectors.
| Tester Connection | Specified Condition |
| NE+ (C20-1) - NE+ (C24-122) | Below 1 Ω |
| NE- (C20-2) - NE- (C24-121) |
| Tester Connection | Specified Condition |
| NE+ (C20-1) or NE+ (C24-122) - Body ground | 10 kΩ or higher |
| NE- (C20-2) or NE- (C24-121) - Body ground |
Reconnect the ECM connector.
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 4.CHECK SENSOR INSTALLATION (CRANKSHAFT POSITION SENSOR) |
![]() |
Check the CKP sensor installation condition.
|
| ||||
| OK | |
| 5.CHECK CRANKSHAFT POSITION SENSOR PLATE (TEETH OF SENSOR PLATE) |
Check the teeth of the sensor plate.
|
| ||||
| OK | |
| 6.REPLACE CRANKSHAFT POSITION SENSOR |
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Clear the DTCs (Click here).
Start the engine.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC output) | Proceed to |
| No output | A |
| P0335 or P0339 | B |
|
| ||||
| A | ||
| ||