Home › ENGINE ยท 2AZ-FE › FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A136021
  1. Disconnect the fuel sender gauge connector.



    A136022
  1. Unlock the fuel sender gauge, and slide it to remove.



2. REMOVE FUEL NO. 1 TANK BAND BRACKET


    A136234E01
  1. Using needle nozzle pliers, remove the E-ring.



    A136232
  1. Disengage the 4 claws of the fuel No. 1 suction support and remove the fuel No. 1 tank band bracket from the fuel suction plate with the fuel filter.

  1. Remove the spring from the fuel suction plate.



3. REMOVE FUEL NO. 1 SUCTION SUPPORT


    A136233
  1. Using a screwdriver with the tip taped, disengage the claw and remove the fuel No. 1 suction support.



4. DISCONNECT FUEL PUMP HARNESS


    A136231
  1. Disconnect the fuel pump harness connector from the fuel suction plate.



5. REMOVE FUEL PUMP


    A136239E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and pull out the fuel pump from the fuel filter assembly.

    NOTICE:
    1. Do not damage the fuel pump filter.
    2. Do not remove the suction filter.



    A136237
  1. Remove the fuel pump harness connector.



    A136238E01
  1. Remove the O-ring from the fuel pump.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A136235
  1. Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator from the fuel filter.



    A096585E03
  1. Remove the 2 O-rings from the fuel pressure regulator.