Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

B112605E01

  1. Disconnect the E6, E7, IO, IK, IM, ID, IA, IF, IJ, and E9 J/B and ECU connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    DCTY (E7-24) - Body ground
    L (*1), Y (*2) - Body ground
    Driver door courtesy switch
    Driver door CLOSED → OPEN
    10 kΩ or higher → Below 1 Ω
    RCTY (E6-5) - Body ground
    GR - Body ground
    Rear right door courtesy switch input
    Rear right door CLOSED → OPEN
    10 kΩ or higher → Below 1 Ω
    PCTY (E6-21) - Body ground
    Y (*1), L (*2) - Body ground
    Passenger door courtesy switch input
    Passenger door CLOSED → OPEN
    10 kΩ or higher → Below 1 Ω
    LCTY (IO-7) - Body ground
    LG - Body ground
    Rear left door courtesy switch input
    Rear left door CLOSED → OPEN
    10 kΩ or higher → Below 1 Ω
    GND2 (IM-9) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    IG (IA-1) - Body ground
    B - Body ground
    Engine power supply
    Ignition switch on (IG) → off
    10 to 14 V → Below 1 V
    GND1 (IF-10) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    ACC (IA-1) - Body ground
    B - Body ground
    ACC power supply
    Always
    10 to 14 V
    L1 (IJ-3) - Body ground
    L(*2) - Body ground
    Driver door control switch LOCK input
    Driver door control switch OFF → LOCK
    10 kΩ or higher → Below 1 Ω
    UL1 (IJ-4) - Body ground
    G(*2) - Body ground
    Driver door control switch UNLOCK input
    Driver door control switch OFF → UNLOCK
    10 kΩ or higher → Below 1 Ω
    L1 (IK-15) - Body ground
    V(*1) - Body ground
    Driver door control switch LOCK input
    Driver door control switch OFF → LOCK
    10 kΩ or higher →
    Below 1 Ω
    UL1 (IK-12) - Body ground
    G(*1) - Body ground
    Driver door control switch UNLOCK input
    Driver door control switch OFF → UNLOCK
    10 kΩ or higher → Below 1 Ω
    KSW (E9-5) - Body ground
    L - Body ground
    Unlock warning switch signal input
    No key is in ignition key cylinder → Key is in ignition key cylinder
    10 kΩ or higher → Below 1 Ω
    LGCY (E6-25) - Body ground
    W - Body ground
    Luggage compartment door courtesy switch input
    Luggage compartment door CLOSED → OPEN
    10 kΩ or higher → Below 1 Ω
    TKUL (E6-2) - Body ground
    R - Body ground
    Luggage compartment door key-linked door unlock input
    Using mechanical key, operate luggage compartment door lock cylinder to LOCK → OPEN → UNLOCK
    10 kΩ or higher → Below 1 Ω → 10 kΩ or higher
    BECU (ID-10) - Body ground
    O - Body ground
    +B (BECU) power supply
    Always
    10 to 14 V
    *1: LHD
    *2: RHD
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the J/B and ECU connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    LSWP (E6-27) - Body ground
    GR (*1), L (*2) - Body ground
    Rear left door lock position switch input
    Rear left door UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    LSWP (E6-27) - Body ground
    GR (*1), L (*2) - Body ground
    Rear right door lock position switch input
    Rear right door UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    LSWD (E7-9) - Body ground
    L (*1), Y (*2) - Body ground
    Driver door lock position switch input
    Driver door UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    UL2 (IK-7) - Body ground
    GR - Body ground
    Driver door key-linked door unlock input
    Using mechanical key, operate driver door lock cylinder to LOCK → UNLOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    L2 (IK-16) - Body ground
    BR - Body ground
    Driver door key-linked door lock input
    Using mechanical key, operate driver door lock cylinder to UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    UL2 (IK-7) - Body ground
    GR - Body ground
    Front passenger door key-linked door unlock input
    Using mechanical key, operate passenger door lock cylinder to LOCK → UNLOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    L2 (IJ-5) - Body ground
    W - Body ground
    Front passenger door key-linked door lock input
    Using mechanical key, operate passenger door lock cylinder to UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    ACT+ (IJ-1) - Body ground
    L - Body ground
    Door lock motor LOCK drive output (Front passenger door)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → LOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT+ (IP-11) - Body ground
    W - Body ground
    Door lock motor LOCK drive output (Rear door LH)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → LOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT+ (IF-5) - Body ground
    L - Body ground
    Door lock motor LOCK drive output (Rear door RH)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → LOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT- (IP-6) - Body ground
    G - Body ground
    Door lock motor UNLOCK drive output (Rear door LH)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → UNLOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT- (IF-18) - Body ground
    B - Body ground
    Door lock motor UNLOCK drive output (Rear door RH)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → UNLOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    TR+ (E7-1) - Body ground
    B - Body ground
    Door lock motor UNLOCK drive output (Luggage compartment door)
    Luggage compartment open switch (Transmitter) or luggage compartment door key cylinder OFF → UNLOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT- (IJ-2) - Body ground
    LG - Body ground
    Door lock motor UNLOCK drive output (Driver door)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → UNLOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT+ (IK-2) - Body ground
    W - Body ground
    Door lock motor LOCK drive output (Driver door)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → LOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT- (IJ-2) - Body ground
    LG - Body ground
    Door lock motor UNLOCK drive output (Front passenger)
    Door control switch (Master switch or passenger side switch) or driver side door key cylinder OFF → UNLOCK → OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    LSWP (E6-27) - Body ground
    GR (*1), L (*2) - Body ground
    Rear right door lock position switch input
    Rear right door UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    LSWP (E6-27) - Body ground
    GR (*1), L (*2) - Body ground
    Passenger door lock position switch input
    Passenger door UNLOCK → LOCK
    Below 1 V →
    10 to 14 V (or pulse generation)
    If the result is not as specified, the main body ECU (instrument panel J/B) may have a malfunction.