Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > IG Power Source Circuit

for Preparation Click here


DESCRIPTION

The main power source is supplied to the A/C amplifier when the ignition switch is turned ON.
The power source is used for operating the A/C amplifier and servo motor, etc.

WIRING DIAGRAM


E130466E01


INSPECTION PROCEDURE

HINT:
Start the engine before inspection. Check the IG1 relay or battery if the engine does not start.

1.INSPECT FUSE (A/C NO. 2)


    E124481E02
  1. Remove the A/C No. 2 fuse from the instrument panel J/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    A/C No. 2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (A/C NO. 2)
OK


2.INSPECT AIR CONDITIONING AMPLIFIER (IG+ - GND)


    E124471E09
  1. Remove the A/C amplifier with its connectors still connected.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E38-1 (IG+) - E38-14 (GND)
    Ignition switch: ON
    10 to 14 V



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

3.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)


    E124470E15
  1. Disconnect the A/C amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E38-1 (IG+) - Body ground
    Ignition switch: LOCK
    Below 1 V
    Ignition switch: ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND)


    E124470E11
  1. Disconnect the A/C amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-14 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER