Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B278A    Short to GND in Immobiliser System Power Source Circuit

for Preparation Click here


DESCRIPTION

This DTC is stored when the engine switch power source supply line is open or shorted.

DTC Code
DTC Detection Condition
Trouble Area
B278A
Engine switch power source supply line is open or shorted.
  1. Wire harness or connector
  2. Engine switch
  3. Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM


B219132E06


INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register all the keys.

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    B278A output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)
  1. Disconnect the certification ECU (smart key ECU assembly) connector.



    B219228E02
  1. Disconnect the engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-30 (VC5) - E70-14 (VC5)
    Always
    Below 1 Ω
    E74-40 (AGND) - E70-8 (AGND)
    Always
    Below 1 Ω
    E74-30 (VC5) - Body ground
    Always
    10 kΩ or higher
    E74-40 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - POWER SOURCE AND BODY GROUND)
  1. Reconnect the certification ECU (smart key ECU assembly) connector.



    B128349E08
  1. Reconnect the engine switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E74-30 (VC5) - Body ground
    Key not in cabin
    Below 1 V
    E74-30 (VC5) - Body ground
    Brake pedal depressed
    4.6 to 5.4 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-40 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

REPLACE ENGINE SWITCH (Click here)