Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Signal Circuit

for Preparation Click here


DESCRIPTION

The headlight beam level control ECU receives the low beam headlights ON signal from the main body ECU.

WIRING DIAGRAM


B137989E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B - HEADLIGHT BEAM LEVEL CONTROL ECU)


    E121520E01
  1. Disconnect the ID instrument panel J/B assembly connector.

  1. Disconnect the A20 headlight beam level control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A20-3 (B2) - ID-3 (HRLY)
    Always
    Below 1 Ω
    A20-3 (B2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE