WINDOW DEFOGGER SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK REAR WINDOW DEFOGGER SYSTEM OPERATION |
When the ignition switch is turned ON and the defogger switch is pressed, check that the rear window defogger operates.
| 2. INSPECT BACK WINDOW (DEFOGGER WIRE) |
![]() |
![]() |
Turn the ignition switch ON.
Turn the defogger switch on.
![]() |
Check the voltage at the center of each defogger wire, as shown in the illustration.
| Voltage | Criteria |
| Approx. 5 V | Wire is not broken |
| Approx. 10 or 0 V | Wire is broken |
Place the voltmeter's positive (+) lead against the defogger wire on the battery side.
Place the voltmeter's negative (-) lead with the foil strip against the wire on the ground side.
Slide the positive (+) lead from the battery side to the ground side.
The point where the voltage drops from approximately 10 V to 0 V is the place where the defogger wire is broken.