Home › TRANSMISSION · U250E AUTOMATIC TRANSAXLE › SPEED SENSOR

SPEED SENSOR > INSPECTION

for Preparation Click here



1. INSPECT SPEED SENSOR (NT SENSOR)


    C113863E05
  1. Disconnect the speed sensor connector from the transaxle.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition (20°C (68°F))
    1 - 2
    560 to 680 Ω
    If the resistance value is not as specified, replace the speed sensor.



2. INSPECT SPEED SENSOR (NC SENSOR)


    C113863E05
  1. Disconnect the speed sensor connector from the transaxle.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition (20°C (68°F))
    1 - 2
    560 to 680 Ω
    If the resistance value is not as specified, replace the speed sensor.