SPIRAL CABLE > INSTALLATION |
| 1. INSTALL SPIRAL CABLE (w/ VSC) |
![]() |
Engage the 6 claws, 2 pins and install the spiral cable to the steering angle sensor.
| 2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR (w/ VSC) |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() |
Engage the 3 claws and install the spiral cable with steering angle sensor.
Connect the connectors to the spiral cable with steering angle sensor.
| 3. INSTALL SPIRAL CABLE (w/o VSC) |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() |
Engage the 3 claws and install the spiral cable.
Connect the connectors to the spiral cable.
| 4. INSTALL STEERING COLUMN COVER |
![]() |
Engage the claw to install the upper steering column cover.
![]() |
Engage the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 5. ADJUST SPIRAL CABLE |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| 6. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel assembly and steering main shaft.
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly.
| 7. INSPECT STEERING WHEEL CENTER POINT |
| 8. INSTALL STEERING PAD |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
![]() |
Support the steering pad with one hand.
Connect the 2 airbag connectors to the steering pad.
Connect the horn connector to the steering pad.
Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
![]() |
Using a "TORX" socket (T30), tighten the 2 "TORX" screws.
| 9. INSTALL NO. 3 LOWER STEERING WHEEL COVER |
![]() |
Engage the claw and install the No. 3 lower steering wheel cover.
| 10. INSTALL NO. 2 LOWER STEERING WHEEL COVER |
![]() |
Engage the claw and install the No. 2 lower steering wheel cover.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT STEERING PAD |
Inspect the steering pad (Click here).
| 13. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).